MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Modular Madness
Reload this Page 4.6L Intake spacer!!!!
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 01-27-2003, 11:11 PM   #19
stangt00
Registered Member
 
Join Date: Dec 2002
Location: Philadelphia PA
Posts: 143
Default
I know exactly what your trying to say. before my current tuning, I noticed on my previous dyno run sheet that my torque stayed higher longer, and my peak hp was spread over a longer rpm range and not just within a hundred rpm, but over 2-250 rpms, it remained real close to the peak.
__________________
2000 GT
80mm Pro-M mass air, 24lb injectors, 75mm BBK T/B, K&N Filter Cold Air, 1/2" Phenolic intake spacer, Underdrive Pulleys, Dyno Tuned Autologic Chip, FMS Shorty Headers, Mac Prochamber 2 1/2" Off Road H pipe, 2 Chamber Flowmasters,
Steeda lowering springs. Steeda Tri-Ax Short Throw shifter, Steeda Power slot rotors w/ Hawk Pro pads, 3.73 FRP Gears. Headwork and Comp cams install in progress.
stangt00 is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Porting lower intake?? Velocity vs. Flow Dark_5.0 Windsor Power 1 11-11-2002 02:42 AM
Speed Secret # 3 jim_howard_pdx Windsor Power 13 11-09-2002 10:35 AM
where can i get a 1'' intake spacer Chevysucks Windsor Power 4 12-10-2001 02:29 PM
Edelbrock spec's and intake question?? jerryIII Windsor Power 0 05-24-2001 12:49 PM
cobra intake spacer? DemonGT Windsor Power 11 05-05-2001 01:52 AM


All times are GMT -5. The time now is 01:12 PM.

Archive - Top

SEARCH