Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-03-2003, 02:40 PM
|
#8 |
|
Registered Member
Join Date: Oct 2001
Location: Florida Keys
Posts: 593
|
If your car is a 91 it is mass air, and you want to keep the bap sensor open. On speed density cars it is a map (manifold absolute pressure?) sensor, but on mass air cars it is a bap(barometric air pressure?) sensor. Find out what was unplugged on your intake first. You should have the fpr hooked up to it, the long black vacuum line from the small 4-line connector (located on the pass side near the firewall) connected to it, there shoul be one large line going from the accesory vacuum tree to the intake, and your pcv valve. All these shoulod be plugged into the back of the intake. What one was disconnected?
__________________
89 notch-finally not stock!! ported gt40's, ported cobra intake, 65mm tb, 75mm maf, mac cai, lt's,prochamber, fms 1.6 rr, 125 shot. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| TIMING 101 for Dumbasses | 1jimmy__d | Windsor Power | 18 | 09-04-2003 11:34 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |