Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-20-2003, 10:03 PM
|
#5 |
|
Registered Member
Join Date: Sep 2002
Location: Dayton, OHIO
Posts: 73
|
I have a set of JBA 1 1/2 unequal shorties I will be putting on in the next couple of weeks. I cant wait to see how they do. I think alot of people are running too large a diameter header. If you have high flowing heads and .550 lift cam I could certainly understand it, but for a street stang with iron heads and under 325 engine HP it doesnt seem to make that much sense. 1 5/8 would probably give you a minor HP increase above 5000 rpm but may sacrifice just as much in torque. 1 3/4..now your talking about some serious HP to fully utilize this diameter. What do you guys think?
__________________
93'GT 5spd. Underdrives, FMS clutch, adjustable quadrant,Flowmasters, Kenny Brown subframe connectors, 3.73 gears, Steeda Tri-Ax. JBA shorties, BBK h-pipe. More to come. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Header to h-pipe bolt size? | squid | Windsor Power | 4 | 02-24-2003 07:08 PM |
| Header and Exhaust Installation | 1991GT | Windsor Power | 4 | 12-03-2002 11:17 PM |
| wheel size | fordkid68 | Stang Stories | 0 | 03-13-2002 07:14 PM |
| Anyone know the nut size for shory header collector studs? | WhiteLX | Windsor Power | 0 | 08-01-2001 04:45 PM |
| Header bolt size | swtstang | Windsor Power | 1 | 05-22-2001 07:03 PM |