Gears

[Miss Mischief]

Originally posted by Miss Mischief
When it comes to Hard parts I have always Relied On TRW I just finished my 2000 V-6 Rear end But I Put the Original 3:73's back Into it they Just happen to be TRW the 3:73's seem to match the engine and all around performance of a stock or slightly Modified 3.8L.

Oh! Very Inportent to Note Here about shims Fluid etc Because everyone changes there gear Oil anually You had better have your Eye open for Metal shavings in the Bottom of the rear end they blend in well and arent easy to pick up make shure you whip the bottom clean any gritty feelling is shaveings the easiest way to pick them up is with a magnet re whip to check for more grit Reapat this Process with a clean Paper towel over and over DO NOT USE bare hands putting some 10w-40 on the paper towel helps the grit and shaveings stick to the paper as well.

Ps this is a Great Time to send out your Stock Drive shaft to have it Balanced as well.