Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-26-2003, 03:43 PM
|
#9 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Okay, Nixon, I'm going to share with you one of my favorite little tid-bits. Go to Sears and buy, or, if you already own a Craftsman 200 piece tool set, you've already got... A set of Ignition Wrenches. They are small, and fit into a little plastic pouch. There are two kinds; one set is nothing more than very thin and short combination wrenches. The other set is also thin and short, but both ends are open end wrenches. One, however, is cockeyed. Find the one that has a cockeyed 3/8" end, if your header bolts are typical. You will then have the one tool, on Earth, that beats all header bolts into submission. It gets them all, and it makes it a snap. You want the one in the middle in each of these pics. The second pic shows how thin these are, but they are TOUGH!
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Check Coolant light on when cold | Tecknowolf | Windsor Power | 2 | 09-14-2003 06:35 PM |
| Hard cold starting? | twilightcall | Windsor Power | 0 | 06-24-2003 06:44 AM |
| cold air intake | TRipSOber | Modular Madness | 13 | 05-01-2003 03:49 PM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| I cannot believe I forgot to ask about Cold Air intakes. | SlowStang2 | Windsor Power | 1 | 07-16-2001 06:26 PM |