Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-31-2003, 12:24 AM
|
#4 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
What about the base though? The base has a very small inlet for that big ole filter....unless by 'air silencer' you mean the base....in which case, how'd you bolt the assembly up? Or did you just use some special type of clamps, screws, rubber bands, bubble gum, etc. to get the filter to stay attached to the upper lid?
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
| Cold air induction | StangGT02 | Modular Madness | 5 | 07-14-2002 03:32 AM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| Cold Air induction.... $7.83 | rbatson | Blue Oval Lounge | 6 | 02-25-2001 01:27 AM |
| cold air induction kit | Brett_C | Small Ponies | 0 | 05-03-1999 05:34 PM |