

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: Jul 2001
Location: Edison, NJ, USA
Posts: 125
|
![]() Out of curiosity, did you fully disassemble the TB when you cleaned it (including plate removal) and if so, did you reset the base idle screw and reset the computer? What about the base timing?
Not sure, but if all else fails maybe the TFI or pickup? To reset base idle, back the idle screw out. Insert 0.010 feeler between screw and stop and turn screw until screw feeler and stop are touching. Pull out feeler and turn screw an additional 1.5 turns. Disconnect (-) battery for 10 minutes, reconnect, start and let idle for a few minutes with accessories off then a few more with all accessories on. Sorry if I told you stuff you already knew. Hope this helps. Rich D. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
I'M FRUSTRATED!!!! (kinda long, sorry) | OMAR | Windsor Power | 26 | 01-04-2004 10:57 PM |
Frustrated! | Neablas | Audio, Security, & Electronics | 4 | 09-10-2003 04:34 PM |
So frustrated! Have you been there?? | Stang_ROTY | Windsor Power | 7 | 07-21-2001 12:04 AM |
MAC Catback - Now I'm Frustrated! | 4cammer | Modular Madness | 0 | 03-01-2000 10:10 PM |