Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-26-2003, 08:10 PM
|
#17 |
|
Gimme a Drink!
Join Date: Dec 2002
Location: NYC
Posts: 694
|
well, took the IAC off and cleaned it with TB cleaner. it was pretty dirty, but i think i could have gotten it cleaner, i just took the 2 screws off, broke it in half by removing 2 more screws, and sprayed the piss out of it, cleaner but still gummed up i think, anyway to clean it better?
i also cleaned the TB while on the car with TB cleaner and the MAF with elec contact spray. i didnt have anymore time so i connected the batt and problem solved! idles around 800 rpms which is good cuz when I put heat on MIX or DEFROSTER, the car will drop about 200 rpm, like its being drained. only on MIX and DEFROSTER, not floor, vent, etc. RPMs dont even drop that much with the a/c on! any suggestions?
__________________
1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "pop" and hesitation at startup | fongo | Windsor Power | 6 | 09-03-2004 01:03 AM |
| Spring startup help? | bouf1128 | Classic Mustangs | 1 | 03-25-2003 09:38 AM |
| initial startup problem, and now it falls flat on its face | fiveohpatrol | Windsor Power | 2 | 08-09-2002 01:24 AM |
| cold startup question? and one more.. | 90dpscoupe | Windsor Power | 3 | 10-21-2001 08:45 AM |
| Need advice on initial startup of mothballed 5.0 | 2QuartzLow | Blue Oval Lounge | 2 | 06-25-2001 03:27 PM |