Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-26-2001, 11:42 AM
|
#6 |
|
Registered Member
Join Date: Jan 2001
Location: Villa Park, IL
Posts: 36
|
If your going with a forced induction (blower) your going to want to go with lower compression. The higher compression you go in a regular motor the higher octane gas you will have to run 10:1 is alright for premium unleaded. With the higher compression your also want to get your timing tunned well. Otherwise you start causing detonation and blowing holes through your pistons. Which is not fun. Try to stay away for the detonation mixture of high compression and low octane.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Stock compression for an 87 5.0 HO??? | Wally | Windsor Power | 3 | 10-04-2002 12:51 PM |
| Stupid Question? | SilverGT02 | Modular Madness | 4 | 07-06-2002 11:01 AM |
| Why do I see some high performance engines w/ breather caps on the oil spout?????? | Stang_ROTY | Windsor Power | 24 | 08-18-2001 12:28 AM |