Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-06-2004, 06:15 AM
|
#4 |
|
Registered Member
Join Date: Apr 1999
Location: Hayes, Va, USA
Posts: 798
|
To be honest, I'm not sure? As long as the AFR heads use the same spacing on the valves and rocker pedstals as stock (or most aftermarket cylinder heads) then the shaft rockers should work (if thats what the shaft rockers were designed for),
I have a set of 185 AFR heads setting on a 347 waiting to go in my 91 one of these days with a set of stud girdles I had originally bought when I was lookng to use a set of canfields, they bolted down on the AFRs just fine so I suspect this spacing is probably stock or at least the same as the canfields. Ultimately my advice would be to contact Steeda and AFR to make sure.
__________________
2002 5M GT (99% stock) 1991 5M LX (30% stock) patiently awaiting my satin silver 07 Mach 1, and don't forget the shaker |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camshaft "GURU" needed !!! Cam question. | 5ohCOUPE | Windsor Power | 1 | 03-26-2003 03:39 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| Follow up to cam swap question - cam gurus needed | mysweetlx | Windsor Power | 3 | 07-31-2002 06:56 PM |
| Newby here, I have a question on Odometers | mustangmama | Blue Oval Lounge | 3 | 03-03-2001 06:43 AM |