Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-22-2004, 09:18 AM
|
#17 |
|
Registered Member
Join Date: Aug 2002
Location: Rochester
Posts: 553
|
Re: Carb has too much idle hole drilled?
OK, One question, The casing is aluminum, water will cause it to corrode quickly especially if boiled. I did this on my 87 Camaro once to clean it and destryed the Carb.. Was a great excuse for a new one however.. hehehe.. Also RTV, BAD!!! on carbs, clogs everything up. I am leary on putting expoxy on the Throttle Blades. it it falls down there and makes its way in the cylinder, you could cause danmages. weld them closed would be best and grind them down smooth...
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| not your everyday carb problem | hobgoblin351 | Classic Mustangs | 8 | 11-04-2003 01:13 PM |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |
| demon carb on 289??? | 69roadrunner | Modular Madness | 1 | 07-21-2001 07:42 PM |