Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2005, 08:29 PM
|
#2 |
|
Registered Member
Join Date: Feb 2005
Posts: 13
|
Re: gt 40-p heads
I believe most all 302's came with a 1/6 rocker on them, as far as the 3 angle valve job goes, I can't say for sure. If I had to guess I would say no, but that's only a guess. How old are these heads? If they have any miles on them I would reccomend a 3 angle valve job. Are you doing the machine work yourself? Good luck with everything. I believe those heads came on explorer's from the factory, but again I could be incorrect. I have been in and out of the mustang hobby since approx. 1995, but I thought I read that somewhere one time. Take care.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is there a visual diff. between the stock e7 and gt 40 iron heads | 93calcobra | Windsor Power | 3 | 11-05-2002 09:58 AM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| 351W heads on 289? | 66 Racer | Classic Mustangs | 4 | 10-18-2001 03:12 AM |
| How about GT-40 heads? | SlowStang2 | Windsor Power | 3 | 07-03-2001 02:02 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |