Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2005, 08:42 PM
|
#3 |
|
Registered Member
Join Date: Apr 2005
Location: Md
Posts: 6
|
Re: front end alignment
I don't have the specs for the 66, but caster is set by adjusting the nuts on the front of the strut rods. Camber is set on 641/2-66 by adding shims to the upper control arms where their bolts go through the apron into the engine compartment. And toe-in is set by adjusting the tie-rod ends. On 67 and later, camber is set by adjusting the eccentric on the lower control arms. If they're telling you they can't adjust caster, then you probably have a bent strut rod. I would look for a replacement instead of allowing anyone to heat it to try to straighten it.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front end feels a little "loose" | Simi Stang | Windsor Power | 4 | 04-29-2004 08:23 AM |
| Front End Alignment | orlowted | Classic Mustangs | 5 | 03-26-2004 08:38 AM |
| front tire wear | horsesnake95 | Windsor Power | 5 | 01-01-2003 12:22 PM |
| Proper front end alignment = better E.T.'s?? | Stang_ROTY | Windsor Power | 15 | 09-05-2002 09:03 AM |
| Front End Alignment | lrrs168 | Modular Madness | 0 | 09-24-2001 04:46 PM |