Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-14-2005, 09:37 PM
|
#4 |
|
Registered Member
Join Date: Apr 2005
Posts: 13
|
Re: Porting stock heads
Wow, looks much messier than stock...Hmm...so a flow bench would be very important in this project? Nope, don't have one of those...was just going to carve out the runners with a dremel and see how close it could be matched.
Hmm, well that sucks, you don't think I'll see much gains from it? Guess I should just fork out 1300 for some Victor Jrs. and swap them over to my 351 with professional porting when I'm done? Sucks, I was looking forward to asking people to run a stock Mustang with spray and dusting the heck outta them  |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Porting Stock Heads? | Whoapony94 | Windsor Power | 6 | 04-09-2002 06:47 AM |
| SystemaxII intake and Box stock RPM heads | NewAge 5.0 | Windsor Power | 4 | 01-18-2002 12:52 AM |
| Anybody use the GT-40P headers on stock heads? | Scappoose | Windsor Power | 3 | 01-15-2002 06:38 PM |
| TFS or Yates Heads on stock block??? | Stang Runner | Windsor Power | 4 | 08-18-2001 02:19 PM |
| Best Heads For Stock Short Block | StreetStang37 | Windsor Power | 2 | 02-26-2001 11:10 AM |