Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-08-2005, 01:31 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
tightening Koni strut nut tips...
I can't tighten the nut on my Koni struts. I have the car jacked up under the a-arm until the tire is just barely off as per instructions.
I used a 1/4 inch allen wrench to secure the nut to a point where it is flush with the top of the strut bolt. Any tips on getting it down a little more??? thanks in advance...
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Koni install tips | Hozer 88GTConv | Windsor Power | 1 | 05-05-2005 09:24 AM |
| Need a decision FAST - Magnaflow 3.5" tips or Borla? | NO SLO PK | Windsor Power | 5 | 02-17-2002 06:21 PM |
| Tips or No Tips? | 95 King GT | Windsor Power | 8 | 07-07-2001 04:08 AM |
| Tightening Strut bolt on top | Z28EATR | Windsor Power | 1 | 02-12-2001 04:10 PM |
| Exhaust tips | Stefan | Modular Madness | 7 | 04-03-2000 06:36 PM |