Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-05-2005, 02:18 AM
|
#3 |
|
Registered Member
Join Date: Jun 2000
Location: ventura,CA
Posts: 438
|
Re: cross threaded, yikes!!!!
If it's only the top couple of threads, you might be able to clean it up with a tap. I'd run a tap thru there and use plenty of high temp silicone on the tube when you reinstall it. If the threads are completely ruined, you might have to drill the hole out and tap it for a helicoil.
__________________
92 GT, 4:10 gears, centerforce clutch, 6# powerdyne blower, bbk h-pipe, flowmasters 65 Mustang 13.50 107mph 3000' ALt. 65 Falcon Straight Axle Drag Car |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| block to cross member lenght issues. | ols0051 | Windsor Power | 0 | 06-14-2005 10:47 AM |
| Cross your fingers for me!!! Just applied to SMU | RedLilPony | Blue Oval Lounge | 6 | 01-22-2003 08:59 PM |
| Josh reaches a cross roads. What to do? | tireburner163 | Blue Oval Lounge | 19 | 04-16-2002 06:04 PM |
| More answers to. "Why did the chicken cross the road?" | tireburner163 | Blue Oval Lounge | 3 | 01-02-2002 01:34 AM |
| Cross Drilled Rotors - Who uses them? | 2FastLX | Windsor Power | 6 | 09-29-2001 12:05 AM |