Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-28-2005, 01:33 AM
|
#4 |
|
Moderator
Join Date: Sep 1998
Location: Grand Rapids, Michigan, USA
Posts: 1,001
|
Re: Dyno simulation, cams for GT40P'd 306
I'm thinking this is likely true, which is why I'm going to run a p/n 35-351-8 CompCams profile tomorrow after class. Hopefully it'll verify this. It's just too bad you can't load a cam profile in more detail in Dyno2k, especially one with different ramp rates.
 Oh, and if I didn't mention it a couple years ago when the notch's AOD finally popped, the timing chain was going bad as well. How far does it have to be worn so that an E303 will idle smoothly as the factory cam?  
__________________
Capri306, Moderator The Mustang Works Online 1979 Mercury Capri 1987 5.0L Mustang LX Notchback 1993 5.8L Eddie Bauer Bronco 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| TFS guides, lost power, and dyno numbers | exgmguy | Windsor Power | 9 | 05-09-2001 09:41 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |