Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-21-2006, 11:58 AM
|
#1 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
GREAT News from the machine shop!
Just heard back from my machine shop, and other than the $854 bill
 I got great news!Crank just needed polished, not cut. Balancing sheet shows front crank plane is only .091 grams out, and rear is .076!!!! Lightened up the whole thing, and the flywheel, new rings, bearings, and fixed the piston problem I had (see earlier thread about ring lands). Machinist is VERY excited for me to get this put back together. SO AM I!!! 
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad news from the machine shop today | 82 GT | Blue Oval Lounge | 11 | 10-13-2002 06:04 AM |
| Back from the Track - Good News/Bad News with Diablo | apenn | Modular Madness | 1 | 09-22-2002 02:50 AM |
| ANOTHER SHOP to avoid!!!!!!!!! | mikestang | Windsor Power | 11 | 10-25-2001 07:27 PM |
| Dyno shop? Where? | bada$$lx | Blue Oval Lounge | 5 | 05-29-2001 07:46 PM |
| Stang Shop In San Diego Area | Kman | Modular Madness | 1 | 09-06-2000 09:00 PM |