
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#1 |
|
a nightmare conversion...
Join Date: Aug 2005
Location: NJ
Posts: 10
|
I have a 1990 mustang pulley setup on my 95 mustang. I also have a supercharger drive crank pulley, 4 inch accessory and 8 inch blower drive.
I did a 331 stroker motor swap in May, and I bought a new 130A alternator for it, and it died 2 months later. I replaced it with a new one, and it just died again this past week (3 months later). Does anyone have ANY insight on this? Are the electronics I am running a bit much where they would zap these new alternators so quickly??? -9 autometer gauges -Flex-a-lite dual fans (set to go on at 180 degrees) -MSD box -basically stock fuel system with a 255 in-tank pump and a Vortech T-rex external pump -42 lb injectors and matching MAF Could it be this, or could it be that the engine's extra heat causing the alternators to die? I noticed a marked higher difference in temperature when I held my hand over a just turned off 331 engine than the 302. Any help?? Anyone!! ![]() |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring A 130a 3g Alt.? | 83GTMUSTANG | Windsor Power | 2 | 06-07-2005 05:23 PM |
| 160A instead of 130A and 75A ??? | White GT | Windsor Power | 0 | 08-09-2003 10:24 AM |
| 93 Tbird S/C, 130A alternator? | red82gt | Windsor Power | 0 | 07-28-2002 01:48 PM |
| What size belt with underdrive pullies, 130A alt. & no A/C | Kamaro Killer | Windsor Power | 3 | 07-25-2002 11:43 PM |
| 130A Alternator on 2.3 | 5.0L_Of_Fury | Blue Oval Lounge | 2 | 07-19-2002 01:31 PM |
