Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-20-2001, 11:50 PM
|
#2 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
I'm putting one in my 66 (which sounds similar to your setup). I am still working out the hydraulic clutch setup and mine will be going in after I finalize the setup. We put one in my buddys 78 vette and it ROCKS. There was an article in 97 where DB Performance put one in a 65.
------------------ 347 (Coast High short block), 279/284, TFS TW heads, Stealth, 750 Holley, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, March serpentine pulley system, Art Carr C-4 (Soon to be a Richmond 6 spd), Currie 9" w/3.50, alum Drv Shft, susp mods, Total Control subframes & tower braces, Trans Am Racing power dual master, 4 wheel disc, 17x8 Torqthrust II's Something up my sleeve  In a 66 coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbo and 6spd Trans for 1997 Cobra? | ErichCA07 | Modular Madness | 8 | 04-28-2005 06:24 PM |
| Richmond Solid Pinion Spacer - Any Good??? | 429mustang | Windsor Power | 3 | 02-25-2004 08:36 AM |
| Ran my car at Richmond Dragway, Richmond Va | MiracleMax | Modular Madness | 2 | 10-07-2003 08:51 AM |
| 19th Annual Mustang & Ford Show - Richmond, Va. | 95SVTCobraVA | Ford Show & Go | 2 | 09-07-2003 09:46 PM |
| Has anyone done a 6spd conversion? | InSaNiUm | Classic Mustangs | 21 | 05-13-2002 07:26 AM |