Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-11-2001, 01:00 AM
|
#2 |
|
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
I've seen articles that said you can get 30hp or so out of stock heads...but that was a professional port job. I'd say you could look for 15 or 20 at most.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ported e7's? | bailey_57 | Windsor Power | 28 | 07-15-2004 07:54 PM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| stock heads | 91PA5liter | Windsor Power | 14 | 07-04-2002 08:21 PM |
| porting stock heads | 89lxinwky | Windsor Power | 5 | 04-12-2002 06:22 AM |
| Stock heads | Smokedawg | Windsor Power | 3 | 04-19-2001 10:16 PM |