Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-15-2001, 03:49 PM
|
#1 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
Longtubes w a Tremec 3550?
I have an SN95 5.0 with a Tremec 3550 and I was wondering if anyone here with the same thing has installed longtubes before? Your supposed to jack up the motor for clearance but with the larger tremec I dont have much room to move. I realy dont want to have to drop my trans just to put these damn things on.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tremec 3550 & SPEC Stage 2 | JRowlette | Windsor Power | 0 | 10-20-2002 10:40 PM |
| What are the gear ratios of a Tremec 3550 | 8850 | Windsor Power | 3 | 10-25-2001 08:36 AM |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| Installing new Tremec 3550 - a few questions | 302 LX Eric | Windsor Power | 6 | 08-23-2001 03:04 PM |
| tremec 3550 swap | 97 Aztec | Modular Madness | 2 | 12-03-1999 09:12 PM |