Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-23-2001, 02:47 AM
|
#8 |
|
Registered Member
Join Date: Oct 1998
Location: Az
Posts: 854
|
they really cant tell you because of variables like head gasket thickness... if the heads are milled, block decked etc...they SHOULD work, but it doesnt hurt to check..
BTW, if you stick new lifters in, soak them in oil over night so they are full when you go to adjust the valves or check the length.. that way they dont compress to quickly
__________________
84 convt,roller 302,AFR's, performer 3.55's, underdrives BBK shorties stock cam, 1.7's 13.58@102.84 and a '68 stang .. project 8 sec street car... 557 big block + N20 :-) http://members.cox.net/darkknight302/68nwrear.jpg |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Got Into Old School Hot Rods. | Mercury | Blue Oval Lounge | 5 | 10-17-2003 11:54 PM |
| 79-89 tie rods vs 90-93 tie rods | 82 GT | Windsor Power | 1 | 02-20-2002 09:35 PM |
| TFTW heads and push rod lengths? | Rev | Classic Mustangs | 4 | 11-23-2001 07:50 AM |
| Push Rods...new ones or not | David Fulford | Classic Mustangs | 2 | 08-03-2001 10:39 AM |
| 351W Connecting Rods | BrainSandwich | Classic Mustangs | 3 | 11-04-1999 10:15 PM |