Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-01-2001, 11:42 PM
|
#12 |
|
Registered Member
Join Date: Apr 2001
Location: Sterling Heights,Michigan
Posts: 129
|
Well, right now I plan on a total rear end overhall. After I installed the clutch allll the power from the engine goes through to the wheels. And has wasted the limited slip. I'am going with the eaton posi because it's rebuildable, 31 spline axles, 4.30 gear and last but not least a rear end cover. Then I would like to get a set of upper and lower control arms, sub-frame's, adj. struts, springs. And then
 take her to Paul's High Performance in Jackson,Mi and hit the engine with some mods like, pullies, ported intake, headers, maf and a dyno tuned chip. I know thats a huge list but I plan on doing almost all the work myself. Ill keep you informed.Will
__________________
SOLD!!! 98Cobra Black on Black Coupe 4.30's DTS diff cover Eaton posi Moser 31 spline axles Spec Stage 2 clutch B&M Ripper shifter BBK off-road x-pipe Steeda pullies Steeda timing adj@14deg MAC cold air Best Time 12.9 @107.5 on street tires New Car 03 Cobra Not Stock |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Buddy Just Bought a 98 Cobra..... | INVINCISTANG | Stang Stories | 10 | 06-25-2002 01:36 PM |
| What's the difference between 95 GT and 95 Cobra? | Ron Brooks | Blue Oval Lounge | 5 | 07-13-2001 12:56 PM |
| New ET 11.457 @ 123.63 in a 99 Cobra! | beefcake | Modular Madness | 1 | 09-25-2000 11:47 AM |