Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-11-2001, 11:25 AM
|
#3 |
|
Registered Member
Join Date: Oct 2001
Location: Kincardine, Ontario, Canada
Posts: 25
|
you are right about the height, the performer 302 with the spacer will actually be taller than the performer RPM. does anyone know forsure if the performer 289 has a rear water crossover, or if the performer rpm 302 has the rear water crossover. and why is it important to have this, should i make sure i get a minifold with this crossover?. Also i was planning on staying away from the performer RPM because i want to make more torque and horsepower lower in the rpm range , and becuase i dont have too radical of a combination (mildly ported E7TE's, 600cfm holley, 1 1/2" full length headers, dual 2 1/2" exhaust with no cats, and no emission equiptment on the engine)
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W crankcase evacuation | jse9 | Windsor Power | 19 | 09-03-2004 12:00 AM |
| Leaking Intake Manifold??? | orlowted | Classic Mustangs | 5 | 05-21-2004 06:19 PM |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| Intake Manifold from 289 fit on 351W? | kirkdickinson | Windsor Power | 9 | 09-27-2003 04:50 AM |
| Intake Manifold Swap | 98gt5sp | Modular Madness | 1 | 09-03-2002 07:11 AM |