Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-03-2002, 04:00 PM
|
#3 |
|
gear banger
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
|
I just did this a few months ago. I got a longstyle ram clutch and 11" flywheel setup with a lakewood bellhousing. The clutch came with a special pivot ball and the directions gave no mesurement for the depth. It just said to adjust it so the throughout bearing comes as close as posible to the pressure plate without touching. It works good.
__________________
79 Hatch: NA 347, Stage 2 Canfield Heads, Victor JR. Intake, Blueprinted Holley 750 HP, Solid Roller Cam, Shooting for 10's on motor 93 LX: Tremec, dual friction clutch, fms flywheel, Hedman shorties, O/R H-pipe Ricer hater's club member #49 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| best clutch and setup? | GhettoPop | Windsor Power | 4 | 10-20-2003 10:40 AM |
| Anyone here have hydraulic clutch setup? | joners | Windsor Power | 0 | 07-19-2003 05:32 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| UPR Clutch Quadrant Setup?? | LOBE_50 | Windsor Power | 10 | 12-11-2001 08:43 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |