Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-20-2002, 05:52 AM
|
#1 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
New heads, rockers...results are at least good
Finally got my TrickFlow TW pocket ported heads and 1.7 TF rockers installed. Ran it around for a couple of hours to break things in before I romped on it. More torque at the bottom end and pulled hard to 6000 RPM. Pretty much as TrickFlow said.
Seat-of-the-pants says improvement, but not monumental. Wouldn't you know that my G-Tech is just now on the blink so I can't even do that comparison. My guess is a few tenths (.3?) improvement. will go to the track next Fri. for a definitive test. Right now I'm kinda glad to have that job done. Apparently my old 351W heads were pretty good, but the new TFTW Al. heads are definitely some better at least. Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What are some good factory heads? | Cameron | Windsor Power | 3 | 04-17-2004 01:44 AM |
| GT-40X Alumin. Heads/ Edlebrock Performer intake. Good combo? | yelowjaket | Windsor Power | 1 | 01-16-2003 03:16 PM |
| Are 1970 302 heads any good | tireburner163 | Windsor Power | 9 | 12-23-2001 09:24 PM |
| scorpion roller rockers... good or bad | spike | Windsor Power | 3 | 08-19-2001 09:38 AM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |