Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-24-2002, 04:01 PM
|
#9 |
|
Registered Member
Join Date: Jul 2001
Location: Dupo,ill
Posts: 219
|
Ok here it is straight from the Motors auto repair manual troubleshooting section. High oil pressure: 1. oil pressure guage defective 2.oil too heavy 3.oil pressure relief valve adjustment too heavy 4. relief valve spring too stiff 5. oil presure relief passage clogged 6. plunger type relief valve stuck by gummy oil or plunger is too tight a fit 7.main oil passages on pressure side of pump clogged Looks like the most likely culprit is the relief valve.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much money to build a high 10 sec Honda (using V-tec engine)? | Fox Body | Windsor Power | 27 | 12-11-2002 08:22 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Pushrod Vs. Modular | chetwindell | Windsor Power | 14 | 06-30-2002 05:56 PM |
| 4.6 vs 5.0 | CactusHugger11 | Modular Madness | 11 | 05-01-2002 01:32 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |