Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-09-2002, 04:58 PM
|
#17 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
The worst you're going to do is fry the $20 Speed Density computer. I would run it with the SD processor, see if you can tune it with fuel pressure. If you can't, you can always use the MAF processor. Just make sure the MAF sensor is NOT hooked up when you have the SD computer in there. I would hate to see something short and fry that sensor. As long as their is no ground on the extra wiring, there should be no current that flows through it.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I'm back, anyone miss me? | rustang girl | Blue Oval Lounge | 18 | 10-10-2002 11:34 PM |
| Back from the Track - Good News/Bad News with Diablo | apenn | Modular Madness | 1 | 09-22-2002 02:50 AM |
| Mass Air Conversion | RoadWarrior | Windsor Power | 2 | 05-23-2002 07:27 PM |
| Time to go back to school. | Unit 5302 | Modular Madness | 12 | 04-27-2002 03:46 PM |
| Converted back to speed density, it works | 88workcar | Windsor Power | 4 | 02-11-2001 08:31 PM |