Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2002, 09:52 PM
|
#6 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
I finally found the post. It was by Slo94 on the Corral:
Qoute: fuel line Don't use stock fuel line! Run some big-daddy stuff and use a good pump! Make sure that baby's got plenty of volume. BTW... I always like to do this on a carb convert... Take out your driver seat and you'll find the fuel pump relay, ground the tan wire w/green stripe and it should put power to the fuel pump wires in the back of the car (with key on)even without the ECM in the car! Then you can hook up your pump and it's operated by the ignition switch still!! Hope this helps!! Thanks for the help though. This was what I was looking for!
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel Pump Problems | blue302 | Windsor Power | 3 | 07-08-2005 10:18 PM |
| Confused, I need help on different fuel pump wiring methods. | 5.0 Fiend | Windsor Power | 12 | 10-14-2004 06:43 PM |
| Fuel Pump Pressure? | Swarzkopf1 | Windsor Power | 3 | 08-31-2004 02:07 PM |
| 94 GT fuel pump relay | phantom74 | Windsor Power | 0 | 02-01-2004 07:14 PM |
| Fuel pump relay questions | Big Bopper | Windsor Power | 1 | 11-10-2002 10:20 PM |