

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Nov 2001
Location: SanAntonio, Tx
Posts: 734
|
![]() Sorry its not a stang question, but its a 95 f-150, I swapped the t.p.s out, it was on the bottom of the TB, So i had to take the tb off
![]() ![]() ![]() Btw, it has 200k miles, but has had routine maintence. also, its not the idle set screw. thnx
__________________
Police package 5spd 90 Lx, Stock original motor, 3.27grs, BM fan, fms 10.5 clutch, D&D quadrant, and adjuster, ADS chip, 180 stat, mac cai, mac h-pipe, mac subframe connectors, ASP crank pulley, ripper shifter, 26x10.5 M/T sport pros welds. 246 hp according to analyzer ![]() Race weight: 3,120 E.t-13.57 with 26x10.50's e.t. streets. 1.88 60' mph- 99.92 mph |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
high rise manifold | fordkid68 | Classic Mustangs | 2 | 05-18-2003 01:38 AM |
306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |