Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-15-2002, 12:40 PM
|
#8 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
I put the 1.7's on a 1990 Lincoln Mark VII (5.0 HO, identical engine) at around 75K, and they were fine. I took them off again at around 100K before I sold the car, and had no problems the whole time. Car ran good and made plenty of power throughout the RPM range.
Maybe the Lincolns get superior valve springs? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| SystemaxII intake and Box stock RPM heads | NewAge 5.0 | Windsor Power | 4 | 01-18-2002 12:52 AM |
| Anybody use the GT-40P headers on stock heads? | Scappoose | Windsor Power | 3 | 01-15-2002 06:38 PM |
| 1.7 Roller Rockers, Hand Porting Exhaust Side Of Stock Heads... Good Idea??? | BowTie Eater 5 Liter | Windsor Power | 12 | 09-15-2001 02:00 PM |
| Best Heads For Stock Short Block | StreetStang37 | Windsor Power | 2 | 02-26-2001 11:10 AM |