Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-12-2002, 06:04 PM
|
#1 |
|
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
How much can you mill TFS TW?
I just pulled off my TFS TW, and one of the heads are slightly warped.
I was going to just have them surfaced, but if I mill them for a little extra compression whats the max they can be milled? They have that big 2.02" intake valve so it cant go too far. If I mill them .030 or .040 what if I need to surface them again in the future? Am I going to have enough head left to do it? Also if I mill them .030 or .040 how much do I need to have the intake milled? Or should I just have them surfaced? Thanks Skyler
__________________
2001 BMW M3 6spd 12.79@108 RIP ---- 1993 Notch w/ 98 4V 4.6 Fasttt... -1989 Saleen Mustang #406- 12.32@109 -1999 Black Cobra Coupe- JBA Shorties, Bassani Cat-X, Magnaflow 3", Pulleys, 85mm Pro-M, Ported Intake, Soild Rear w/ 4.30s, Tubular Front End, X2C arms, 13lb batt, few others. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DSS compression/ milling questions/ pushrods | stangin it | Windsor Power | 2 | 02-24-2004 05:51 PM |
| Engine Swap Problems..97Gt to new 99IP Mill | fissit | Modular Madness | 3 | 08-20-2003 05:37 AM |
| Mil Eliminators????? | medrvstang01 | Modular Madness | 2 | 06-13-2002 01:02 PM |
| Chambersize and comp (stock heads)? and mill?? | joakim | Windsor Power | 9 | 02-11-2001 06:22 PM |