Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-24-2002, 12:22 AM
|
#1 |
|
Registered Member
Join Date: Dec 2000
Location: Rochester NY
Posts: 21
|
clearance
should i check the valve to piston clearance on this setup? edelbrock performer heads 1.60 1.90, f-cam w/ 1.7 roller rockers. (i cant remember if the springs handle .560 or .590 lift, this is my buddies combo, im guessing .560) thanks.
__________________
1988 GT Remanufactured 302 Holley systemax I, cold air induction, 76mm C&L MAF conversion, underdrive pulleys, 24# injectors, 190lph fuel pump, equal length shorty headers, off road h-pipe, force II catback, PRO 5.0 shifter, fuel pressure oil pressure & water temperature gauge, crane valve springs |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston to Valve Clearance Check - 351W | Peldor | Classic Mustangs | 4 | 01-31-2008 08:29 PM |
| Valve cover baffles and rocker clearance... | Hozer 88GTConv | Windsor Power | 1 | 11-10-2002 01:26 PM |
| full leanght header ground clearance | bosco | Windsor Power | 3 | 01-28-2002 03:03 PM |
| Piston to valve clearance - How much do I need? | 2FastLX | Windsor Power | 6 | 03-29-2001 04:54 PM |
| forged piston cylinder wall clearance on rebuild? | markduanetaylor | Classic Mustangs | 1 | 03-08-2001 02:38 PM |