Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-02-2002, 10:12 AM
|
#4 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Then you need to replace the ECT (Engine Coolant Temp sensor). You also need to set your TPS. After doing both of those, reset the ECM by disconnecting the neg battery cable, then turning on the headlight switch for 10 minutes, then turn it off, and reconnect the battery cable. Go for a 20 minute test drive, come back, and run KOEO codes again.
Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pulled codes...what do they mean? | Hethj7 | Windsor Power | 8 | 06-12-2003 12:03 PM |
| Pulled New Codes Today | Mountain Main | Windsor Power | 11 | 06-11-2003 02:10 AM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled Codes from Car, Need Help! | StreetStang37 | Windsor Power | 11 | 09-24-2001 05:58 AM |