Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-15-2002, 04:54 PM
|
#12 |
|
NX dealer-man
Join Date: Sep 1998
Location: Peoria, Illinois
Posts: 977
|
...I picked up 20rwhp over baseline for a grand total of 340 with a setup not too far off from what I run now... Naturally aspirated, of course, then factor in the 200 shot and changes made after the dyno pull (and the times I run...) which puts me somewhere in the neighborhood of 550+ @ 3100lbs. w/ driver.
Sorry for butting in on the conversation, but I'm subscribed to the thread and have been reading along... thought you might wanna know anyhow.  Good Luck with your combo's guys... I wanted to build a 331 this winter. All I have at the moment is an R block... so I'm prolly gonna transplant the 306 rotating assem from the stock block over to the R block and add some more spray, shoot for some 10.0's or 9.90's next spring. Take care |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| Check out these times and tell me how i can get better! | 1jimmy__d | Stang Stories | 6 | 06-24-2003 01:07 PM |
| New Track times On the good old SD and STOCK Short block | Stang Runner | Stang Stories | 1 | 10-10-2002 06:25 PM |
| Quarter mile times | 67 Demon | Classic Mustangs | 11 | 05-30-2002 12:40 AM |
| stroker engine question | 82 GT | Windsor Power | 1 | 06-08-2001 03:22 PM |