Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-28-2002, 05:03 PM
|
#6 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
The kit is from Incon and it's the 800TTi kit. Good for up to 800 HP. It comes with the full turbo assemblies as well as the intercooler. It also came with everything needed to install the kit like plug wires, fuel pump and all clamps and hoses. It was a truly complete kit. The only thing that I did not care for was that the exhaust side of the turbo assembly (exhaust manifold, turbine housing and dump tube) came uncoated. I'm not a big fan of rust so I took them to a local shop here and had them disassemble all of the parts and then had them coated. Actually, they were triple coated with a gray insulated coating and then coated with a ceramic coating to make it look good. The gray coatings were used to keep the heat in the exhaust and to protect the ceramic coating.
The problem is that Incon is having lots of problems. It looks like they're going out of business. Too bad, they made a great kit. About $4500
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbo vs SC Sounds like good advice | mustardjohn | Small Ponies | 0 | 11-16-2003 05:21 PM |
| Ran a turbo Integra, a Grand National, and two bikes!!! | WhiteT78Supra | Stang Stories | 23 | 07-19-2002 07:21 AM |
| Turbo in n/a 2.3? | pxcr_600 | Small Ponies | 1 | 06-21-2002 12:20 PM |
| What's needed to build a Turbo 5.0L? | Gautam | Windsor Power | 1 | 06-07-2001 05:34 PM |
| How do I know if the turbo is working? | Trevor | Small Ponies | 3 | 07-20-1999 10:35 PM |