Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-08-2002, 08:28 PM
|
#1 |
|
Registered Member
Join Date: Sep 2002
Location: Macomb IL
Posts: 42
|
don't want to over cam my car
I have all the parts for my 302/331 stoker short block except a cam and and a set of pistons (can't decide). I think i also want to go with an alphabit cam but still want some low end power. I am
headed towards "F" But sence its a stoker it should have more torche anyway. So would would F be to much for the streets. I say ford cause i don't know much about any other brands. So i would consider any cam idea's except for Crane. And Where can i get some decent pistons (low compression) cheap? And any comments about a 331 stroker would be helpful too. Every little bit could help later on. One last thing... This engine is for a daily driver w/attitude kinda car.
__________________
94 GT (Full length headers, Off Road H Pipe and Flowmasters) MSD Ignition, 75 shot nitrous, cold air induction. 65mm t.b. pulleys and 3:73 gears. everything else STOCK!! 60' = 2.04; 1/4 = 13.9 on street tires dynoed with 87 octane at 240hp 310 lb torch w/out nitrous. Its a pooch but im working on it. |
|
|
|
|