Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-11-2002, 10:45 AM
|
#3 |
|
T.P.M. President
Join Date: May 2002
Location: Brownsville
Posts: 265
|
Being a little burnt out on being on and under my car, I went down to AZ and borrowed the coolant sytem pressure tester. I pumped her up to 17 and listended for leaks. Pressure was good with no visible or audible leaks so I jiggled the upper radiator hose and it hissed at the radiator. I took off the hose and noticed that the radiator inlet was no a perfectly round, but actually a little mishapen. I tightened down the clamp on an unbent portion, repressurized, jiggled, and voila. I thought I was slick. Then I drive her the 20 minutes back to work in 90 deg sunny weather w/ the AC on and it didn't heat up at all. I stop to put gas and popped the hood to feel the pressure in the hoses...NO PRESSURE! God I hate working on the thermostat. Two bolts and no room to work...
Thanks PK |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEED HELP!!, cooling system problem | TRICK_5_0 | Windsor Power | 2 | 08-21-2003 10:02 AM |
| How to completely drain a 5.0's cooling system??? | Italianstanger | Windsor Power | 1 | 07-13-2002 11:18 AM |
| how about a revese flow cooling system? | nitrousjunkie | Windsor Power | 2 | 04-01-2002 12:45 AM |
| How to clean cooling system??? | Fostang | Windsor Power | 1 | 07-15-2001 06:13 AM |
| Cooling System problems | 1973Mach1 | Classic Mustangs | 7 | 06-25-1999 10:33 PM |