Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-01-2002, 09:32 AM
|
#4 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
to answer your original question, if youtake out the heater core you won't do any damage to the car as long as you make sure to connect the hoses so coolant can still flow properly. The only thing that will change is it will be a little bit colder in there.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Buy a U.S 1994 V8 5L GT Mustang in Australia (Imported from Japan)? | fearby.com | Windsor Power | 8 | 09-10-2002 09:27 AM |
| Need advice for a 95 mustang GT | chickendreamer | Windsor Power | 3 | 09-06-2002 02:55 PM |
| Advice needed for a futur Mustang owner | Steph | Blue Oval Lounge | 8 | 10-21-2001 11:21 PM |
| Fastlane Motorsports Mustang meet and show, Aug 11, Salina KS... | Garyput | Blue Oval Lounge | 7 | 08-07-2001 10:44 PM |
| 68 mustang weight | Skyman | Classic Mustangs | 3 | 01-29-2000 12:55 AM |