Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-05-2002, 03:56 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I like the sound of the "x" cam but i don't like the idea of having a problem with piston clearance. Getting the pistons fly cut is not an option with me. Does anyone in here run the x cam without any clearance problems? I mean if i keep the stock ratio roller rockers will i have a problem with clearance?
What about crane? Do they make something like the b cam that has power up through 5500 rpms? or maybe something like the x cam but not so beefy as to cause clearance problems?
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Specs on my Camshaft | Kisner | Classic Mustangs | 2 | 08-01-2004 12:55 PM |
| ported gt40's and stock camshaft | chiaronate | Windsor Power | 11 | 04-14-2004 05:15 PM |
| Camshaft Question | SmokinStangGT | Windsor Power | 7 | 10-20-2003 12:40 AM |
| camshaft gains w/new stuff | 84LX89GT | Windsor Power | 5 | 06-30-2003 09:18 AM |
| camshaft selection | chiaronate | Windsor Power | 2 | 06-09-2003 02:17 AM |