

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#3 |
Registered Member
Join Date: Feb 2003
Location: Still Ugly as ever
Posts: 111
|
![]() This is a serious mod, usually performed for an all-out road race effort. I can't think of anyone here who has done this. If you want better weight distribution, I'd start by using aluminum heads (cuts 50 lbs. off the nose) and relocate the battery to the hatch area.
Those Mods The Heads Battery Relocation and Bealive this Or Not Lead weights Under the Rear seat Gain Positive balance and achieve Better Take Off, and With the Right Rubber Is Much less a hand Full of Car In Cornering. I got the Lead weights Idea from a SVT wrench Who Weighted My cars Nose "Front wheels" and Back side "Rear wheels"at a Truck weighting station He then Bolted Flat Lead weights Under The Rear seat even with the sleeper 15" Frost white rims I can Get a whole Shot in First with only a slight bark and very Low to No Nose lift.
__________________
Miss Mischief RHC#153 Proud to carry the Card ![]() 2000 V-6 5 speed Frame Braces [Steeda] [Wanna be Cobra] 17" Rims with Kuhmo 245's 5 Spoke Gunmetal finish [Power Dyne] Blower Unpolished 6 psi {Mods to Come} [Steeda] Springs slightly lower then stock [Steeda] Anti sway bars front and rear. 1999 Jeep Cherokee Big six 5 speed Infinty Bose steroe Lots of Creatures Comforts [Mods] Brush/ Push bar Full length Welded and Bolted , Tow Hook Front and Rear 30" Goodyear AT's . |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
1988 5.0l lx | Spat | Windsor Power | 7 | 08-10-2002 11:18 AM |
lx trunk lid??? | 19907up | Windsor Power | 1 | 08-06-2002 02:45 PM |
1991 Back Seat Bracket??? | jz_mustang50 | Windsor Power | 0 | 10-07-2001 08:39 PM |
Mustang suspension | Skankin | Corner Carvers Delight | 1 | 08-17-2001 05:10 PM |
smoked a lx hatch | sedanman | Stang Stories | 2 | 01-10-2001 07:30 PM |