Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2003, 06:41 PM
|
#10 |
|
Registered Member
Join Date: Sep 1999
Location: Dundalk, Ont, Canada
Posts: 129
|
Before I say anything this is extremly dangerous CAN RESULT IN DEATH
Through the compressor away. Put the strut back on. Take the two lower arm bolts out. Get the car as High as you can and pry the lower arm down. If you cannt get the car high enough you will need to get that compressor back. Once the spring is in use a jackstand placed in the centre of the two bolts (the bottom section of the A) to hold the A arm slowly lower the car the arm will go into place. Hope this helps. If you are not sure you should take it to a shop. I used to work with these alot and it will rip your head off.
__________________
88GT, 331Stroker,FMS 70mm TB,77mm Pro-M mass air,Ram Air,K&N,GT40/Exployer Intakes,Gasket Matched,FMS 24lb injectors,Crane hi-6 ignition system,B303 cam,Crane 1.6RR,FMS underdrive pullies,351W/heads,port/polish,FMS h/f oil pump,Hedman headers,2 1/2in H pipe Flow Masters,190lph Holley fuel pump,Center Force dual friction,FMS 3.55,Hurst short throw/ trigger T handle,Subframe connectors,Welded torque boxes. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front eibach pro-kit spring installation | mtv not bullets | Windsor Power | 1 | 01-05-2004 10:05 PM |
| Front Coil Spring Installation | Mac_5.0 | Windsor Power | 4 | 05-28-2003 11:09 AM |
| Front spring help, ASAP! | Chris_H | Windsor Power | 5 | 05-12-2003 07:12 PM |
| Front spring removal question... | BLACK85GT | Windsor Power | 6 | 01-17-2003 10:43 AM |
| Front spring and strut install | gray87GT | Windsor Power | 0 | 06-17-2001 05:54 PM |