Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-20-2003, 07:26 PM
|
#4 |
|
Get down.....
Join Date: Apr 2001
Location: Room 103
Posts: 2,095
|
make sure the enigine is fully warm. disconnect IAB motor while the car is running. Set the rpm where you want it. turn the car off, reconnect the IAB and start the car. your done. I never had to do a relearn procedure anytime i adjusted fords minimum air flow.
James
__________________
Cobra brakes are on! Finally..... ------------------------------------------------ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| idle speed sensor | BOW TIE SMASHER | Windsor Power | 4 | 10-22-2002 09:56 PM |
| Idle problem 88GT Speed Density | chuck88 | Windsor Power | 9 | 07-07-2002 09:16 AM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| High idle speed out of no where. | SlowStang2 | Windsor Power | 9 | 07-11-2001 03:43 PM |
| paging:ALL SPEED DENSITY GURUS, E303=surging idle | slow87GT | Windsor Power | 7 | 02-14-2001 02:28 PM |