Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-30-2003, 06:21 AM
|
#1 |
|
Registered Member
Join Date: Jan 2000
Location: Feeding Hills, MA
Posts: 114
|
Calling everyone with a High Flow In-Tank Pick-up
What type of fitting are you using on the –10 feed side of the pick-up. I tried using a straight fitting but it hits the side of the frame rail and will not allow my tank to go back into position, with out putting a bad kink in the line.
What did you do to make it fit. PLEASE HELP……
__________________
Procharged 351W. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
| Pressure build up in Gas Tank | Fuglee | Windsor Power | 1 | 08-21-2003 02:22 PM |
| How to turn a high pressure in tank pump into a low pressure pump!! | crazypete | Windsor Power | 6 | 09-30-2002 11:10 AM |
| Is trick flow high port to much for my combo? | rnunnnery | Windsor Power | 2 | 02-25-2002 09:35 PM |
| Fuel Tank Question | RMARIANI | Windsor Power | 3 | 10-15-2001 03:29 PM |