Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-10-2003, 08:31 AM
|
#4 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
If you have access to a press, compress the spring somewhat, and get some heavy duty rope from a hardware store and tie it down in the compressed position. It helps to figure out what angle it will go in easier, and tie the rope on the side that will give you that correct angle. Install, then cut the rope off later.
Was the ONLY way I could get mine to go in. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| front eibach pro-kit spring installation | mtv not bullets | Windsor Power | 1 | 01-05-2004 10:05 PM |
| Front Coil Spring Installation | Mac_5.0 | Windsor Power | 4 | 05-28-2003 11:09 AM |
| Front Spring Install | PeTr0 | Windsor Power | 11 | 04-02-2003 06:21 PM |
| Front spring removal question... | BLACK85GT | Windsor Power | 6 | 01-17-2003 10:43 AM |
| Front spring change | blk88lx | Windsor Power | 2 | 03-31-2002 02:40 AM |