© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
Thread Tools | Rate Thread | Display Modes |
08-04-2003, 03:24 PM | #1 |
Registered Member
Join Date: Sep 2000
Location: rock hill,S.C. 29730
Posts: 420
|
Does this sound right? E7's milled .035 no detination with 10 deg & 87 octane??
I had them decked .035 and due to gas prices i was running 87 w/10 degrees initial timing seems i should of raised the compression a good bit but no pinging @ 10* still 87 octane??
does this seem possable? Also i home ported heads and intake, opened exhuast to stock gasket open them up a lot, gasket matched intake ports about 1" deep ,I also port matched lower intake (head side) took out a lot of aluminum even wore a hole in #5 runner. anyway do you guys think i should raise fuel press.? Thanks sorry so long... |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
octane vs. compression | gizmo83 | Windsor Power | 9 | 08-22-2002 12:17 PM |
gasoline prefrence | chatcher | Windsor Power | 29 | 03-08-2002 09:37 PM |