Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2003, 12:54 AM
|
#4 |
|
Registered Member
Join Date: Aug 2002
Location: SanAntonio, Tx
Posts: 957
|
The guys at the machine shop told me you cant go real deep on gt-40's cuz of water passages, if i were you i would just clean up the intake side, and cut out a good amount on the exhaust and polish smooth).
my intake was hogged out, carved on the upper inlet, and opened up the lower pretty good, on the lower part of the runners they made a swirl rough polish for turbulence. I would recomend a 3 angle valve job also. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ran a '01 GT | EZRIDN | Stang Stories | 3 | 08-29-2001 08:17 PM |
| GT and LS-1 get into Tangle. GT WINS!! | Mercury | Stang Stories | 8 | 06-26-2001 12:49 PM |
| I Lost my first race in my 2000 GT | Mercury | Stang Stories | 10 | 05-27-2001 10:39 PM |
| Where can I find GT 40 Irons? | chris91LX | Windsor Power | 1 | 03-12-2001 06:09 PM |
| Just got an awesome race w/ a white '91 GT convertible (1-20-01, 11:30 pm) | Fox Body | Stang Stories | 3 | 01-22-2001 09:00 AM |