Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-31-2003, 03:53 PM
|
#11 |
|
Gimme a Drink!
Join Date: Dec 2002
Location: NYC
Posts: 694
|
is the TFI module going bad a common stang problem? how do you know if your TFI is going bad, i would assume the car would not run?
also my stang got 118k on the clock, should i replace the orig TFI module for pieve of mind? Ford part of aftermarket recommended?
__________________
1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ball joint replace in a 65 - how hard is it? | Steriti | Classic Mustangs | 5 | 07-03-2004 05:32 PM |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Fuel Pump or TFI Module ??? | mimicons | Windsor Power | 1 | 05-13-2003 02:35 AM |
| Is it hard to replace coil springs? Should I pay? | jpumpkinn | Windsor Power | 3 | 06-27-2001 11:46 AM |
| 8" Traction-lock clutches...how hard to replace | Rev | Windsor Power | 2 | 02-11-2001 06:03 PM |