Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-24-2003, 04:21 PM
|
#5 |
|
Registered Member
Join Date: Jun 2000
Location: Sechelt, B.C., Canada
Posts: 200
|
Hey guys ...,
I was wondering if there is a way to check the lifters manually..?? I'm kinda broke right now and can't afford a whole new set of lifters..and I don't want to drive my rag top in the snow  Can I take them out and bench test them some way? Thanks for all the help...also do you think I could sand off the rough edges of that valve stem end ? then just adjust the valve lash? I know this is bad way of doing things but I have know choice ,,...I'm on strike...wife says "SPEND NO MONEY" Thanks in advance guys...Big Bopper
__________________
90' GT Drop-top, 88' 302,pulleys,full flowmasters (turndowns),Ported stock Intakes,twin flex-a-lites,Pro-5.0,3.55's,short belt,elctric water pump,timing bumped,taylor leads.(headers soon!) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Will my stock or aftermarket h-pipe bolt up to a 4 valve? | Redstang96 | Modular Madness | 0 | 08-29-2002 09:56 PM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |